GE Traction Motors - CAD Railway

GE AC TRACTION MOTORS

GE 41A296328BFP6 Traction Motor Sensor T21343

Too low to display
  • Review
  • TAG : GE Traction Motor for Locomotive
ADD TO CART

  • ge traction motor datasheets and application notes. . CYCLES TO FAILURE TYPICAL WIRE , : Typical Mission Profile for rail traction application Stress .


    Snow, traction motor failure and ground faults. Discussion of General Electric locomotive technology. Current official information can be found .

    Dec 21, 2008 . Installing the traction motor to the Milwaukee Streetcar (again). . CATASTROPHIC Electric Motor Failure - A Winding Shorted FIRE . Freezing Weatherby pcgenius940,711 views · GE Locomotive Traction Motor Spike testing .


  • Dec 21, 2008 . Installing the traction motor to the Milwaukee Streetcar (again). . CATASTROPHIC Electric Motor Failure - A Winding Shorted FIRE . Freezing Weatherby pcgenius940,711 views · GE Locomotive Traction Motor Spike testing .


    ge traction motor datasheets and application notes. . CYCLES TO FAILURE TYPICAL WIRE , : Typical Mission Profile for rail traction application Stress .

    M&R of all Ross Hill, GE and IPS SCR and drives, traction motors. Assisted with mechanical repairs to generators and mud pumps. Supervised all rig move .

    GE. Transportation. The product of choice for D90 traction motors. New and UX Motors • Compatible to EMD* • Built By GE . successful in developing our D87BTR traction motor more . Reduces hot spots and premature winding failures .

    The locomotive repair shop.
    Clever - a table set up for cutting fabrics or rubber sheeting from a roll.
    I can only imagine what a steel table this robust might be used for.
    Nice. A wide sheet-metal shear with an extension rail to support the sheet and a jib crane for material handling.
    A high-capacity hydraulic press brake. High-production models add computer-controlled back stops. Note both hands are required to operate it, for safety.
    A nice large power slip roll, for curving sheet steel. I wonder what thickness this will handle...
    This lathe was purpose-built for turning wheel hubs and journals on axles.
    Not exactly a Bullard, this machine was purpose-built for boring wheels.
    Loading another locomotive axle assembly into the wheel press. It normally takes 400 lbs of pressure to force the wheel onto the axle. Nothing locks the wheel onto the axle, other than the axle being too big for the wheel bore.
    After the wheels are pressed on, Timken roller bearings are bolted to the axle ends. Note the caps at lower right, which have a serrated edge for wheel slip detection.
    Finished wheel sets for GE locomotives, ready for their traction motors. The bar codes are new in the railway supply industry, for better analysis of lot performance.
    GE traction motors.
    Finished traction motor combos.
    A GE locomotive truck. Assembly is a lot easier if it's upside down.


  • ge traction motor datasheets and application notes. . CYCLES TO FAILURE TYPICAL WIRE , : Typical Mission Profile for rail traction application Stress .

GE Traction Motor Gears and Pinions.

T58080 - Cam Car Bolt Pneumatic Installation / Removal Kit - GE AC Traction Motors


This kit was designed for use on the GE AC traction motor nose supports. It is used to install Cam Car Bolts by twisting the drive tang off ensuring proper installation. In addition a removal socket is included for removal of the bolt.

CAUTION: Ensure that the air motor is running off clean air supply with a mist of lubricating oil.



Would you like a quote on this item? Enter a quantity below to add to the Request for Quote Cart